Installation - Kogan KAPWDBIDETA User Manual

INSTALLATION

Precautions before Installation
•
Before installation ensure toilet wall, floor tiles, ceramic toilet have all been
installed. Your bathroom should have water supply and power socket nearby toilet.
•
Water pressure should be between 0.06Mpa (flow) - 0.75MPa (Static), water
temperature 5°C - 35°C.
•
In case of transportation in subzero (freezing) condition, place the product in a
warm place and wait for any residual water to thaw before installing.
•
Connect daily-use water pipe only. Use tap water or drinkable well water only. Do
not connect to recycled water or industrial water supplies, due to possible
contamination as this would cause jamming or internal damage.
•
Be sure to use T valve and filter.
•
Ensure the water supply is fully connected before connecting the bidet to the power
outlet.
1. Install T valve with filter
•
Lock inlet valve to remove water pipe (Figure 1).
•
Connect T valve with filter and inlet valve (Figure 2).
•
Install flush tank and inlet pipe (Figure 3).
Water
pipes
Figure 1
T valve
filter
Valve
OFF
Figure 2
Flush tank
Gasket
Valve
Valve
Figure 3