Installation - Kogan KAPWDBIDETA Quick Start Manual

Installation

Installation Environment
1. Before installation of the toilet seat, the toilet wall, floor tiles and ceramic toilet should
be completely installed, the bathroom should supply water and there should be a 220-
240V power socket nearby.
2. Water pressure should be between 0.06MPa (flow)-0.75MPa (Static), water
temperature 4°C-35°C.
3. In case it has frozen, please put the product in a warm place and wait to thaw and
then install it.
4. Connect with a daily-use water pipe only.
5. Do not connect to recycled water or industrial water supplies. Due to possible
contamination, this could cause jamming or internal damage.
6. Please be sure to use incidental T valve and filter.
7. Don't put the power plug into the socket before finishing installation.
Install T Valve
1. Lock inlet valve to remove water pipe. See Picture 1.
2. Connect T valve, filter and inlet valve. See Picture 2.
3. Install flush tank and inlet pipe. See Picture 3.
Install Bidet
1. Remove original toilet seat:
Lose the nut.
Take out the toilet seat.
6