Kogan KAPWDBIDETA User Manual page 17

Rear wash/Oscillating:
Press this button and the rear wash nozzle will extend for operation. Press again to change
to rear oscillating cleansing. The #1 indicator will blink on the remote control, while the nozzle
repeatedly swings back and forth. Press again to stop oscillating cleansing and switch back
to rear wash.
Front wash/Oscillating:
Press this button and front wash nozzle will extend for operation. Press again to change to
front oscillating cleansing. The indicator #1 will blink on the remote control, while the nozzle
repeatedly swings back and forth. Press again to stop oscillating cleansing and switch back
to front wash.
Stop:
Stop the current operation. Press and hold this button for 3 seconds to shut down toilet seat.
Nozzle position adjustment:
Press the "Front" and "Rear" buttons to adjust the position of the nozzle. The nozzle position
cannot be adjustment while oscillating.
Water pressure adjustment:
During wash operation press the "Strong" or "Weak" buttons to adjust the water pressure.
Dryer:
Press this button to start the warm air-drying operation. This operation automatic ends after
4 minutes or when the user presses the "Stop" button.
Warm air temperature adjustment:
Whilst drying, press the "Strong" or "Weak" buttons to adjust warm air temperature to suit
your needs.
Nozzle self-cleaning:
Press the "Nozzle" button on remote control while in standby mode. The water will start to
flow to clean the nozzle. Press this button repeatedly and the nozzle switches between rear
and front cleansing and then you can clean and replace the nozzle.
Note:
Standby mode means that the toilet seat is in an operational state. The toilet seat is
not in the state of washing, drying, nozzle self-cleaning, etc.