Table of Contents
Advertisement
INSTALLATION
Precautions before Installation
•
Before installation, ensure toilet wall, floor tiles and ceramic toilet have all been
installed. Your bathroom should have water supply and power socket nearby toilet.
•
Water pressure should be between 0.06Mpa (flow) - 0.75MPa (Static) and water
temperature between 5°C - 35°C.
•
In case of transportation in subzero (freezing) conditions, place the product in a
warm place and wait for any residual water to thaw before installing.
•
Connect daily-use water pipe only. Use tap water or drinkable well water only. Do
not connect to recycled water or industrial water supplies, due to possible
contamination as this would cause jamming or internal damage.
•
Be sure to use the T-valve and filter.
•
Ensure the water supply is fully connected before connecting the bidet to the power
outlet.
1. Installing T-valve with filter
•
Close inlet valve and remove water pipe (Figure 1).
•
Connect T-valve with filter to the inlet valve (Figure 2).
•
Connect the flush tank to the T-valve using the water piper (Figure 3).
Water
pipes
Figure 1
T-valve
with filter
Valve
OFF
Valve
Figure 2
Flush tank
Gasket
Figure 3
Valve
Advertisement
Table of Contents
