Tripp Lite B64-032-04-IPG Owner's Manual page 62

Remote Session Operation
Control Panel
(continued)
User Macros
The User Macros page allows you to add macros to the KVM switch
that can be performed on any of the connected computers using the
Macro List feature of the control panel. (See Macro List section under
Control Panel in Remote Session Operation for details.) By default,
the User Macros page is displayed when the Hotkeys / Macros icon is
clicked on. To display the page when it isn't selected, click on the User
Macros button at the top of the Hotkeys / Macros screen.
To create a macro, follow the steps below.
1. Click the Add button on the right side of the screen.
2. In the name field that appears, key in a name for the macro you are
adding.
3. With the new macro highlighted, click the Record button on the
right side of the screen. Recording will begin and the following
panel will be displayed in the upper-left corner of the remote
screen.
4. Enter in the macro hotkey sequence and then click the Done
button. You will be returned to the User Macros screen, with your
macro name and hotkey combination added to the list. Repeat this
procedure for any additional macros you wish to create. Note:
Clicking the Pause button will pause/unpause the recording of
the hotkey sequence. Clicking the Cancel button will cancel the
recording of the hotkey sequence. Clicking the Show button will
display the hotkeys as they are entered.
(continued)
System Macros
The System Macros page allows you to add macros to the KVM
switch that can be performed automatically upon closing a session.
For example, you can create a macro that sends the Winkey-L
combination, causing a computer's login page to come up the next
time it is accessed. To display the System Macros page when it isn't
selected, click on the System Macros button at the top of the Hotkeys /
Macros screen.
To create a macro, follow the steps below.
1. Click the Add button on the right side of the screen.
2. In the name field that appears, key in a name for the macro you are
adding.
3. With the new macro highlighted, click the Record button on the
right side of the screen. Recording will begin and the following
panel will be displayed in the upper-left corner of the remote
screen.
4. Enter in the macro hotkey sequence and then click the Done
button. You will be returned to the System Macros screen, with
your macro name and hotkey combination added to the list. Repeat
this procedure for any additional macros you wish to create. Note:
Clicking the Pause button will pause/unpause the recording of
the hotkey sequence. Clicking the Cancel button will cancel the
recording of the hotkey sequence. Clicking the Show button will
display the hotkeys as they are entered.
Once system macros are created, they are available to be assigned
to ports, with only one macro allowed per port. (See the Port
Configuration section under OSD Operation for details on assigning
system macros.)
62