Tripp Lite B64-032-04-IPG Owner's Manual page 6

Introduction
(continued)
Components
(continued)
Rear View
5
2 3
1 4
No . Component
Power Sockets (C14)
1
Power Switches
2
Secondary LAN Port
3
(LAN 2)
Primary LAN Port
4
(LAN 1)
Grounding Terminal
5
Modem Port
6
Local Console Ports
7
Server Ports
8
Note: The figure above shows the rear panel of a B064-032-04-IPG or B064-032-02-IPG. The B064-016-04-IPG and B064-016-02-IPG differ
in that it only has a single block of 16 KVM ports.
6 7
Description
The two C14 power sockets are located here. Connect the included power cords (C13 to 5-15P) from here to an
appropriate power source. Note: To help protect your system from sudden, transient increases and decreases
in electrical power, it is recommended that you plug your devices into a Tripp Lite surge protector, line
conditioner or uninterruptible power supply (UPS).
The On/Off switches for the two power supplies are here.
The cable that connects the KVM switch to the backup network plugs in here.
The cable that connects the KVM switch to the primary network plugs in here.
Connect the included grounding wire to this terminal to ground the KVM switch.
An optional dial-in connection is available for use in the event the KVM switch is not available over the Primary
or Secondary networks.
This area features VGA and DVI ports for the connection of either a VGA or DVI monitor, as well as two USB
ports for the connection of a keyboard and mouse. Note: The B064-008-01-IPG and B064-016-01-IPG will not
feature a DVI-D port but instead two PS/2 ports for connection of mouse and keyboard.
Cat5e/6 cable connects between these ports and the SIUs to connect computer/servers to the KVM switch.
8
6