Motorola MVME5100 Manual page 45

Auto Boot Abort Delay = 7?
The time in seconds that the Autoboot sequence will delay before starting the boot. The
purpose for the delay is to allow you the option of stopping the boot by use of the
The time value is from 0-255 seconds. (Default = 7 seconds)
Auto Boot Default String [NULL for an empty string] = ?
You may specify a string (filename) which is passed on to the code being booted. The maximum
length of this string is 16 characters. (Default = null string)
ROM Boot Enable [Y/N] = N?
Y The ROMboot function is enabled.
N The ROMboot function is disabled. (Default)
ROM Boot at power-up only [Y/N] = Y?
Y ROMboot is attempted at power-up only.
(Default)
N ROMboot is attempted at any reset.
ROM Boot Enable search of VMEbus [Y/N] = N?
Y VMEbus address space, in addition to the usual
areas of memory, will be searched for a
ROMboot module.
N VMEbus address space will not be accessed by
ROMboot. (Default)
ROM Boot Abort Delay = 5?
The time (in seconds) that the ROMboot sequence will delay before starting the boot. The
purpose for the delay is to allow you the option of stopping the boot by use of the
The time value is from 0-255 seconds. (Default = 5 seconds)
ROM Boot Direct Starting Address = FFF00000?
The first location tested when PPCBug searches for a ROMboot module. (Default =
0xFFF00000)
ROM Boot Direct Ending Address = FFFFFFFC?
The last location tested when PPCBug searches for a ROMboot module. (Default =
0xFFFFFFFC)
Network Auto Boot Enable [Y/N] = N?
Y The Network Auto Boot (NETboot) function is
enabled.
N The NETboot function is disabled. (Default)
MVME5100 Installation and Use (V5100A/IH5)
3 PPCBug Firmware
key.
BREAK
key.
BREAK
25