Auto Wipe And Auto Light For Vehicles With Large Overhangs - Ford TRANSIT CUSTOM 2012.75 Mounting Manual

4.16.3 Auto Wipe and Auto Light for vehicles with large overhangs

Item
1 Conversion or Installation rearward (zone 1) where Auto Light and Wipe feature will function
correctly.
2 Conversion or Installation forward (zone 2) where Auto Light and Wipe feature will NOT function
correctly
3 Auto sensor location.
NOTE: The Auto Wipe, Auto Light feature should
not be ordered for vehicles that are to be built
where the installation covers any part shown
forward of the vehicle see figure E147777. This will
affect the auto sensors ability to detect light or
moisture to the defined calibration and will not
function correctly.
In the event that a donor vehicle has been supplied
with these features, the dealer can configure the
vehicle to manual light and wipe with the following
settings.
• Set Central Car Configuration parameter 24 –
With Rain sensor to 01: (Without Rain Sensor)
• Parameter 88 for Auto Light should be set to
01: (Without Auto Lights)
It is also recommended that the Auto Light main
switch is changed for a non auto switch. If not
changed when selecting auto position (A), the
dipped beam will remain on (due to a not valid
condition) and the system will run in fail safe
mode. Dipped beam will be operated at Ignition
on and with Engine RUN. If the wiper is selected
with the light switch in (A) the wiper will work as
if intermittent mode has been selected. A Ford
Dealer can help advise which switch should be
ordered and fitted, starting with part number
BM5T-13A024-** (depending on the specification
of the vehicle).
Date of Publication: 04/2012
124
The feature is not to be specified with the donor or configured OFF by the Ford dealer.
Description
FORD TRANSIT CUSTOM 2012.75