Table of Contents
Advertisement
Third Brake/Stop Light
Third Brake/Stop Light Connectors
Item
A
Left Connector Pin 5 on 14405 Harness - Yellow/Grey
B
Right Connector Pin 10 on 14A005 Harness - Yellow/Grey
A signal for a third brake/stop light is also available
on the tail light connector.
In order to avoid electrical issues due to leakage,
and to ensure connector compatibility, a mating
connector with seals/plugs and pre-crimped wire
and terminal should be used.
For connectivity, see following Figure E151249 and
the details given in the section for Reverse Signal.
The third brake light feed can be accessed from
the body side connector of 14405 harness (left,
pin 5) or 14A005 harness (right, pin 10) which
connects to the door harness 13B472. These
connectors are located at the rear of the vehicle
near the interface of the rear door or lift gate
wiring. This circuit can only have a relay added
(maximum 300mA) to control additional lighting.
Check with your local Ford dealer or National
Company Sales representative for conversion
compatibility.
The use of the trailer tow connector is not
recommended. In situations where it is necessary,
please see the following figure E151250. This
connector can be found at the 14406 interface
with the 13B576 harness. Pin 6 is the stop light
feed. The trailer tow module BK2T-13B576-A_ will
Date of Publication: 04/2012
122
Description
need to be fitted to get the system active. For full
trailer tow kit, BK2T-13B576-D_ is also required.
For additional information on electrics for tow bars:
Refer to: 4.1 Wiring Installation and Routing Guides
(page 56).
Trailer Tow Connector
Item
Pin 6
Stop Light Feed
FORD TRANSIT CUSTOM 2012.75
Description
Advertisement
Table of Contents
