Calculating The Data Volume; General; Firmware Versions For Calculating The Data Volume; Calculating Data Volumes - Fronius Datamanager 2.0 Operating Instructions Manual

Calculating the data volume

General

When operating Fronius Datamanager 2.0, data is generated and needs to be transmit-
ted online.
In order to select a suitable internet connection it is necessary to calculate the data
volume.
The following data volume calculation provides an overview of the amount of data gener-
ated when operating Fronius Datamanager 2.0.
Firmware Ver- The data volume calculation is based on Fronius Datamanager 2.0 firmware versions V
sions for Calcu- 3.3.x-x and lower.
lating the Data
Volume Higher firmware versions can cause a higher data volume due to their increased func-
tional range.
Calculating data The data volume calculation depends on which Fronius Datamanager 2.0 functions are
volumes activated.
Function
Make real-time data
available in Fronius Sol-
ar.web
View real-time data in
Fronius Solar.web
Send archived data/
logging data to Froni-
us Solar.web
Send service messages
or errors
Only after a restart or if the internet connection has been disconnected
1
)
2 Calculation of memory sectors per day according to chapter "Calculating memory capa-
city" on page
)
Depending on the quality of the internet connection
3
)
IMPORTANT! Since the values listed in the table are "rough data" for Fronius Dataman-
ager 2.0 and the provider's bill may show discrepancies as a result of the various meth-
ods of calculating the transfer volume, the total value should be increased by 10–20%.
16
Data volume
1)
Once
Current overall view
per sensor card/sensor box
Current comparison view
per inverter
Start page
System comparison view
Transmission time
For daily sending
per service message or error
For immediate sending
per service message or error
68
(Memory sectors per day
3)
150 bytes
32 KB/h
42 KB/h
+ 300 KB/h
13 KB/h
+ 4 KB/h
0 KB/h
0 KB/h
2)
x 4 KB) + 8 KB
600 bytes/min
1 KB/day
+ 300 bytes
1 KB