Lens Section; Lens Assembly - Sony HXR-NX80 Service Manual

3-15.

Lens Section

3-15-1.

Lens Assembly

Preparation
1. Remove the cabinet (G) assembly. (Refer to
2. Remove the heat sink (GP) assembly. (Refer to
3. Remove the GR-1003 board. (Refer to
4. Remove the top cabinet assembly. (Refer to
5. Remove the EF-1003 board. (Refer to
6. Remove the IR-1009 board. (Refer to
7. Remove the inner mold (T) assembly. (Refer to
8. Remove the cabinet (R) assembly. (Refer to
9. Remove the BT panel assembly. (Refer to
10. Remove the ZM-1005 board. (Refer to
11. Remove the VF assembly. (Refer to
12. Remove the MS-1037 board. (Refer to
13. Remove the VC-1045 board. (Refer to
Procedure
1. Peel off the CM radiation sheet (915).
Note
The CM radiation sheet (915) is not reusable. Prepare new parts in advance.
(1) Turn the the VC radiation sheet (B) as shown in the figure.
(2) Peel off the CM radiation sheet (915).
Lower side
Note
When attaching the CM radiation sheet (915), align it with the scribe lines.
HXR-NX80/HXR-MC88
"3-2. Cabinet (G) Assembly".)
"3-3. Heat Sink (GP)
"3-4. GR-1003 Board".)
"3-5. Top Cabinet Assembly".)
"3-6. EF-1003 Board".)
"3-7. IR-1009 Board".)
"3-8. Inner Mold (T)
"3-9-1. Cabinet (R) Assembly".)
"3-10-1. BT Panel Assembly".)
"3-11. ZM-1005 Board".)
"3-12. VF Assembly".)
"3-13. MS-1037 Board".)
"3-14. VC-1045 Board".)
Scribe line
Assembly".)
Assembly".)
VC radiation sheet (B)
Scribe line
CM radiation sheet (915)
3-45