Sony HXR-NX80 Service Manual page 36

2. Remove the EF-1003 board.
(1) Release the boss a, boss b from the two holes, and then remove the EF button.
(2) Disconnect the flexible flat cable from the connector (CN4608) on the GR-1003 board.
(3) Remove the screw.
(4) Release the boss a, boss c from the two holes, and then remove the EF-1003 board.
(5) Pull the flexible flat cable through the gap of the inner mold (T) assembly.
(6) Disconnect the flexible flat cable from the connector (CN2901) on the EF-1003 board.
GR-1003 board
Flexible flat cable
EF button
Precision screw
(P1.7 x 4)
Holes
Flexible flat cable
Note
When installing the EF-1003 board, pass the flexible flat cable through the gap of the inner mold (T) assembly as
shown in the figure, and then hook it on the hook.
3. Install the removed parts by reversing the steps of removal.
HXR-NX80/HXR-MC88
Gap of the inner mold (T)
CN4608
Holes
EF-1003 board
Arrangement of flexible flat cable
Flexible flat cable
CN2901
Boss c
Boss a Boss b
Inner mold (T) assembly
Hook
3-10