Aggressive Cleaning Agents; Danger To Health Due To Improper Disposal; Obligations Of The Owner; Instructions For Use - Bartec APEX px Operating Instructions Manual

Manual ex p control unit
Table of Contents

Advertisement

Safety

Aggressive cleaning agents

Danger to health due to improper disposal

Obligations of the owner

Instructions for use

Page 14 of 96
When selecting the correct cleaning agent, it is essential that it is suitable for
use since otherwise damage may occur to seals and connections. Combustible
products are generally not permitted.
According to the European WEEE Directive, electrical and electronic equipment
may not be disposed of with household waste. Their components must be sent
separately for recycling or disposal because toxic and hazardous components
can cause long-term damage to health and the environment if not disposed of
properly.
As consumers, you are obliged under the Electrical and Electronic Equipment Act
(ElektroG) to return electrical and electronic equipment at the end of its
serviceable life free of charge to the manufacturer, the point of sale or to public
collection points set up for this purpose. Details of this are regulated by the
respective national law. The symbol on the product, the operating instructions
or/and the packaging refers to these regulations. With this type of material
separation, recycling and disposal of old devices, you make an important
contribution to the protection of our environment.
The owner undertakes to restrict permission to work with and on the APEX
control unit to people who:
are familiar with the basic regulations on safety and accident prevention
and have been instructed in the use of the APEX control unit;
have read and understood the documentation, the chapter on safety and
the warnings.
The owner must check that the safety regulations and accident prevention
rules valid for the respective application are observed.
The overvoltage category II of the non-intrinsically safe circuits according
to IEC 60664-1 must be observed.
The warning "WARNING – DO NOT OPEN UNDER VOLTAGE" must be part of
the external marking of the entire electrical device or the enclosure must
have a locking system to prevent the fuses from being energized during
replacement.
01-37A2-7D0001_px_Manual_Exp-Control-Unit_20210923_0_en.docx
Ex p Control unit
APEX
px
Rev. 0

Advertisement

Table of Contents
loading

Table of Contents