Remove The Upper Case (With Keyboard And Touchpad) - Lenovo CAMPUS THINKBOOK 16P G2 Hardware Maintenance Manual

Figure 41. Remove the LCD module

Remove the upper case (with keyboard and touchpad)

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 29
"Remove the solid-state drive (SSD) module" on page 30
"Remove the battery pack" on page 32
"Remove the Wi-Fi card" on page 32
"Remove the DC-in bracket" on page 33
"Remove the memory module mylar" on page 34
"Remove the memory module" on page 34
"Remove the heat sink" on page 35
"Remove the fans" on page 36
"Remove the solid-state drive (SSD) bracket" on page 37
"Remove the USB board module" on page 37
"Remove the CMOS battery" on page 39
"Remove the speakers" on page 39
"Remove the touchpad board cable" on page 40
"Remove the system board" on page 41
"Remove the fingerprint board module" on page 43
"Remove the hall sensor board module" on page 44
"Remove the keyboard cable" on page 45
"Remove the connector board module" on page 46
"Remove the strip cover" on page 47
"Remove the LCD module" on page 49
Go to
https://support.lenovo.com/partslookup
part:
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
51