Remove The Strip Cover - Lenovo CAMPUS THINKBOOK 16P G2 Hardware Maintenance Manual

Figure 34. Remove the keyboard backlight cable
Step 3. Separate the keyboard backlight cable from the connector board
Figure 35. Separate the keyboard backlight cable from the connector board
Go to
https://support.lenovo.com/partslookup
replacement parts:
Connector board
Keyboard backlight cable

Remove the strip cover

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 29
"Remove the solid-state drive (SSD) module" on page 30
"Remove the battery pack" on page 32
"Remove the Wi-Fi card" on page 32
"Remove the DC-in bracket" on page 33
"Remove the memory module mylar" on page 34
"Remove the memory module" on page 34
"Remove the heat sink" on page 35
"Remove the fans" on page 36
"Remove the solid-state drive (SSD) bracket" on page 37
"Remove the USB board module" on page 37
"Remove the system board" on page 41
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
47