Remove The Solid-State Drive (Ssd) Bracket; Remove The Usb Board Module - Lenovo CAMPUS THINKBOOK 16P G2 Hardware Maintenance Manual

Remove the solid-state drive (SSD) bracket

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
"Remove the memory module mylar" on page 34
"Remove the heat sink" on page 35
Step 1. Remove the right fan and one SSD.
Note: For details, see "Remove the fans" on page 36 and "Remove the solid-state drive (SSD)
module" on page 30.
Step 2. Remove two screws and then remove the SSD bracket.
Figure 19. Remove the SSD bracket
Screw specifications
M2.0 x L3.5
Go to https://support.lenovo.com/partslookup
part:
Solid-state drive (SSD) bracket

Remove the USB board module

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
"Remove the solid-state drive (SSD) module" on page 30
"Remove the battery pack" on page 32
"Remove the memory module mylar" on page 34
"Remove the heat sink" on page 35
"Remove the solid-state drive (SSD) bracket" on page 37
Step 1. Remove the right fan.
Note: For details, see "Remove the fans" on page 36.
Number of screws
1
1
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
37