Remove The Upper Case (With Keyboard And Touchpad) - Lenovo 20V30007IX Hardware Maintenance Manual

Figure 28. Detach the antenna cable connectors and disconnect the EDP cable from the system board
Step 3. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove four screws and then remove the LCD module.
Figure 29. Remove the LCD module
Screw specifications
M2.5 x L5

Remove the upper case (with keyboard and touchpad)

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the battery pack" on page 29
"Remove the solid-state drive (SSD)" on page 30
"Remove the Wi-Fi card" on page 30
"Remove the memory module" on page 31
"Remove the heat sink" on page 32
"Remove the fan" on page 33
Number of screws
4
.
Chapter 4 Removing a FRU or CRU
43