Remove The Upper Case (With Touchpad, Power Button, Keyboard, Waterproof Breath Film And Antenna Cables); Disassemble The Lcd Module - Lenovo 16ACH6H Hardware Maintenance Manual

Figure 32. Take out the EDP cable and then remove the LCD module
Remove the upper case (with touchpad, power button, keyboard,
waterproof breath film and antenna cables)
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the battery pack" on page 31
"Remove the solid-state drive (SSD) plate" on page 33
"Remove the solid-state drive (SSD)" on page 34
"Remove the solid-state drive (SSD) stand off" on page 35
"Remove the thermal module" on page 35
"Remove the Wi-Fi card" on page 36
"Remove the DC-in bracket" on page 37
"Remove the I/O board" on page 38
"Remove the memory module" on page 39
"Remove the CMOS battery" on page 40
"Remove the speakers" on page 41
"Remove the touchpad board cable" on page 41
"Remove the system board and the I/O board cable" on page 42
"Remove the strip cover" on page 44
"Remove the LCD module" on page 45
Go to
https://support.lenovo.com/partslookup
part:
Upper case (with touchpad, power button, keyboard, waterproof breath film and antenna cables)

Disassemble the LCD module

The LCD module as a whole is not an FRU. Instead, it contains FRUs as its components. Before
disassembling the LCD module, make sure it has been detached from the upper case.
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
47