Figure 27. Remove the LCD module
Remove the upper case (with keyboard and touchpad)
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the battery pack" on page 31
"Remove the solid-state drive (SSD)" on page 32
"Remove the solid-state drive (SSD) stand off" on page 32
"Remove the Wi-Fi card" on page 33
"Remove the hard disk drive (HDD) module" on page 34
"Remove the memory module" on page 35
"Remove the heat sink" on page 36
"Remove the fan" on page 36
"Remove the I/O board" on page 38
"Remove the RTC battery" on page 39
"Remove the DC-in bracket" on page 39
"Remove the system board and the I/O board cable" on page 40
"Remove the LCD module" on page 42
Go to
https://support.lenovo.com/partslookup
part:
Upper case (with keyboard and touchpad)
Disassemble the LCD module
The LCD module as a whole is not a FRU. Instead, it contains FRUs as its components. Before
disassembling the LCD module, make sure it has been detached from the upper case.
Remove the strip cover
Make sure the following FRU (CRU) has been removed.
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
43