Step 2.
Remove two screws and then lift the LCD module carefully.
Figure 30. Remove two screws and lift the LCD module
Screw specifications
M2.5 x L7
Step 3.
Take out the EDP cable and then remove the LCD module.
Figure 31. Take out the EDP cable and then remove the LCD module
Remove the upper case (with touchpad, keyboard, waterproof breath
film and antenna cables)
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the solid-state drive (SSD) plate (L)" on page 31
"Remove the solid-state drive (SSD) plate (R)" on page 32
"Remove the solid-state drive (SSD)" on page 33
"Remove the solid-state drive (SSD) stand off" on page 34
"Remove the battery pack (Legion 5 15IAH7H, Legion 5 15IAH7)" on page 34
"Remove the touchpad board cable" on page 36
"Remove the speakers" on page 36
46
Hardware Maintenance Manual
Number of screws
2