Lenovo CAMPUS THINKBOOK 16P G2 Hardware Maintenance Manual page 37

Figure 7. Remove two screws
Screw specifications
M2.0 x L3.5
Step 4. Remove the SSD module by pulling it away from the slot.
Figure 8. Remove the SSD module by pulling it away from the slot
Step 5. Remove the SSD holder.
Note: The SSD holder is not reusable. Replace it when replacing related FRUs.
Figure 9. Remove the SSD holder
Step 6. Peel off the SSD Cu foil mylar.
Note: The SSD Cu foil mylar is not reusable. Replace it when replacing related FRUs.
Figure 10. Peel off the SSD Cu foil mylar
Go to https://support.lenovo.com/partslookup
replacement parts:
Number of screws
2
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
31