Panasonic KX-HCM110A Operating Instructions Manual page 97

Setting
Enable Image
Buffer/Transfer
Trigger
Alarm enable
condition
4.
Set the time, and click [Next>].
Note
The timer works by an internal clock. Set the date and time before using timer
buffer/transfer (see page 70).
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Setting
A day of the
week
Active Time of
Trigger
• Check the box to enable the Trigger setting. Clear the box
to disable it.
• Selecting [Timer] enables the camera to buffer/transfer the
image by timer.
• Selecting [Alarm 1 or 2] enables the camera to buffer/
transfer the image by alarm signal.
• Selecting [Motion Detection] enables the camera to
capture/transfer the images when the motion detects
something.
• Selecting the method of the detection for an alarm
connected to the External I/O terminal.
• Select [Rising: GND to Open (High).] or [Falling: Open
(High) to GND.]. [Rising: GND to Open (High).] is the state
that GND pin and pin 1 or pin 2 is left open.
[Falling: Open (High) to GND.] is the state that GND pin
and pin 1 or pin 2 is short-circuited. (See page 145)
• Check the box to enable the day. Clear the box to disable it.
• Select the [Always] option when you do not specify the time
period. If you specify the time period, select the time period
option and set the time period.
[For assistance, please call: 1-800-272-7033]
Description
Description
Operating Instructions
97