Table of Contents
Advertisement
4 Package content
• NMEA Connect Plus
• MAC, Wifi Access Point SSID and password, Bluetooth Device Address (BD_ADDR),
printed on a label inside the black gateway. This information is also available in a label
on the packaging.
• Quick Reference Manual is printed on the package, latest version available to download
at
www.calypsoinstruments.com
*Note: NCP needs some accessories for functioning. These accessories can be purchased
on our website at www.calypsoinstruments.com . We remain at your disposal for any other
inquiry.
5 Functionalities
The NCP can receive information via NMEA 0183 or BLE.
When several input interfaces are available, the NCP will use the wind data from the interface
that first comes to the NCP and select it as receiver (if NMEA 0183 input interface is
connected, this one is the first to be detected). The wind data of that interface is converted or
repeated to all outputs available.
5.1 POWER
The NCP can be powered from several sources:
•
NMEA 2000 backbone power: when connected, the NCP is powered from it. This
option is compatible with 12VDC supplies typically using 126mA (3 LEN) at 12 VDC.
This power source is isolated from the rest of the circuit.
When the NCP is connected to the NMEA 2000 bakcbone, no additional power is
needed.
•
Dedicated VCC input: A dedicated 12VDC input can be used to power the NCP.
•
USB power: Available when other sources are not available. When other source is
available the USB power drain is minimal.
5.2 USB
USB can be used to power the unit (optional) and to upgrade the Firmware.
In order to use it you need a USB cable with end free wires. Take a look at section 6.1
for further information regarding the connection of the USB.
5.3 NMEA 2000® interface
The NMEA Connect Plus is equipped with an NMEA 2000 interface to connect to an
NMEA 2000 backbone.
Advertisement
Table of Contents
