Calypso Nmea Connect Plus User Manual page 10

NCP will translate NMEA 0183 wind sentences into NMEA 2000 PGN's (messages).
This feature enables a seamless integration between NMEA 0183 and NMEA 2000
navigation devices.
Also wind data received via BLE is converted into NMEA 2000 protocol and
transferred to an NMEA 2000 network.
When connected to the NMEA 2000 backbone, the NCP receives its power from it, no
additional power is needed. A correct powered and terminated NMEA 2000 network
is required before using this interface.
When the NCP is used on a NMEA 2000 network, the NCP backbone cable with end
free wires should be connected through the unit (follow the instructions in section
6.2).
To connect the NCP to the NMEA 2000 network, you should connect the drop cable
male connector to the female connector of the NMEA 2000 backbone (note: the key
in the male connector and the keyway on the female connector). Make sure the
cable is connected securely and that the collar on the cable connector is tightened
firmly.
5.3.1 PGNs
Wind data is sent using the PGN 130306.
The following table shows the NMEA 2000 PGNs supported.
NMEA 2000 Parameter Group Numbers (PGNs)
PGN #
59392
60928
60416
Transmission 126208
126464
126993
126996
126998
130306
59904
60928
Reception 60160
60416
65240
126208
PGN Name
ISO Acknowledgment
ISO Addess Claim
ISO Transport Protocol, Connection Management
NMEA Acknowledment Group Function
PGN List (Transmit and Receive)
Heartbeat
Product Information
Configuration Information
Wind Data
ISO Request
ISO Address Claim
ISO Transport Protocol, Data Transfer
ISO Transport Protocol, Connection Management
ISO Commanded Address
NMEA Request/Command Group Function