Table of Contents
Advertisement
• NMEA 0183: to check if the NCP is sending data through NMEA 0183
output interface, connect your computer (RS485 connection) to a RS485
output port of the NCP (you will need a RS485 to USB converter). In your
computer use a 'Serial/TCP Port terminal' such as 'Realterm', 'TeraTerm',
etc.. Open it and configure it with the serial COM port associated to the
connection and with the Baudrate configured in the NCP (see Website
'Configuration page' to check the baudrate selected), once the serial
connection is open, you should receive the NMEA 1083 wind sentences.
• NMEA 0183 Wi-Fi server: to check if the NCP is sending data through
NMEA 0183 server port, connect your computer and your NCP to the
same Wi-Fi network (see section 5.7and 5.8). In your computer use a
'Serial/TCP Port terminal' such as 'Realterm', 'TeraTerm', etc.. Open it and
Advertisement
Table of Contents
