Table of Contents
Advertisement
4. Tighten the holder in order to fix the cable and close the gateway with the screws.
(To achieve the IP68 rating, all glands must be occupied by round-section cables of
between 4.5mm and 10mm or be replaced by blanking plugs)
5. Attach the NMEA Connect Plus securely to the vessel.
6. When all wires are connected and the gateway is closed, connect the cables to your
network and power them if necessary (when using an NMEA2000 network the NCP will
be powered through the NMEA 2000 cable. No additional power is needed)
6.1 Connect USB interface
Identify the USB connector and put the wires in the correct position.
The USB signals and colour code are shown in the following table:
Advertisement
Table of Contents
