Installation - Calypso Nmea Connect Plus User Manual

Note: The connection manager will report "No Internet" which is correct as your device
is now connected directly to the NCP Access Point which does not provide internet
access.
The NCP built‐in configuration can always be accessed by typing in the IP address:
192.168.4.1 into the address bar of your Wi‐Fi enabled PC or devices web browser.
5.8 WIFI-Station
The NCP can be used as Wi‐Fi Station to be connected to your Wi‐Fi network. This
enables you to access the Configuration Webserver and your Wi‐Fi wind data from
any point of your network. See section 8.1to configure it.

6 Installation

Before you start the installation make sure all power sources are off!!
To connect a cable to the NCP internal interface follow the steps below:
1. Remove the screws to open the NMEA Connect Plus gateway. The connectors are in the
position as the following image shows.
CAN Connector
RS-485 Connector
and Power
2. Loosen the holder to introduce the cable inside and pass the cable through the hole.
Three holders of different diameter are provided; select the one that best fits your cable
diameter to ensure the IP68 rating.
3. Connect the wires in the correct position according to the information given in the
following sections. To put the wire into the connector, push with your finger or with a
tool.
USB
Connector