Removing The Circuit Boards - Epson DFX-5000+ Service Manual

Removing the Cover Open Sensor
1. Remove the upper case. (See the description on the previous page.)
2. Turn over the upper case. Remove the 2 CPB (M2 x 8) screws from the case
open sensor and remove the sensor.
Figure 3-17. Removing the Cover Open Sensor
R e m o v i n g t h e C i r c u i t B o a r d s
Removing the Bottom Panel Assembly
steps below. Refer to
weight on the top cover or any other printer components.
caught between the lower case and bottom panel.
1. Remove the left and right side covers. (See Removing the Left, Right, and
Front Covers and Replacing the Fuse on page 3-12.)
2. Open the rear cover. Remove the 4 CPB (M3 x 12) screws and 2 CPT (0) (M3 x
12) screws securing the interface cover and remove the cover.
EPSON DFX-5000+ Service Manual
Caution
Removing the Top Cover for
Disassembly and Assembly
instructions.
3-17