Epson DFX-5000+ Service Manual page 40

Product Description
The tear off and paper select functions are not available when the paper
Note :
memory function is used.
Using the Paper A4em ory Function
To use the paper memory function, you must first save paper format and
thickness information for up to two different types ofpaper as described in the
section below.
To turn on the paper memory function after saving your paper format and
thickness information, hold down one ofthe buttons below and turn on the printer.
MICRO FEED (
MICRO FEED (v)
To turn offthe paper memory function and use normal paper, hold down the
PAPER SELECT button and turn on the printer.
Notes: Q A l-inch skip over perforation area is automatically included for
overlapping forms.
function; however, ifthe skip length is less than 1 inch, the setting is
ignored when using overlapping forms.
memory function with overlapping forms.
each time you load paper.
Saving Paper Form at and Thickness Inform ution
To save paper format and thickness information for overlapping forms, forms with
a label, or overlapping forms with a label, follow these steps:
1. Turn offthe printer
2. Use DIP switch 3-4 to select the memory area where you want the printer to
store the paper format and thickness information. Memory area 1 is selected
when DIP switch 3-4 is off. This is the printer's default setting. To select
memory area 2, turn on the switch.
Table l-9. Selecting the Paper Memory Area
3. Use DIP switches 3-l and 3-2 or software commands to set the page length.
1-26
) Recalls the paper format and thickness information stored
A
in memory area 1.
Recalls the paper format and thickness information stored
in memory area 2.
Paper Memory Area
1
DIP SW 3-4
I I
ON
EPSON DFX-5000+ Service Manual