Intelligent Overheat Protection; Low-Voltage Warning; Headband Assembly; Wearing Ways - Fenix HP30R Quick Start Manual

Table of Contents

Advertisement

One constant on: 40% ‐ 20% 
One flashes: critical 20% ‐ 1% 
Note: This only works with Fenix ARB‐L21‐5000 battery. 
 
Intelligent Overheat Protection 
The lamp will accumulate a lot of heat when used at relatively high modes for extended periods. 
When the lamp reaches a temperature of 60°C or above, the lamp will automatically step down a 
few  lumens  to  reduce  the  temperature.  When  the  temperature  drops  below  60°C,  it  will  then 
allow the user to reselect the modes.   
 
Low‐voltage Warning 
When the voltage level drops below the preset level, the headlamp is programmed to downshift 
to a lower brightness level until Low mode is reached. When this happens in Low mode, the lamp 
blinks 3 times every 5 minutes to remind you to timely recharge or replace the battery. 
Note: This only works with Fenix ARB‐L21‐5000 battery. 
 
Headband Assembly   
The headband is factory assembled by default. 
Adjust the headband by sliding the buckle to the required length. 
If the headband is stained with sweat and mud, it can be washed directly. 
 
Wearing Ways   
 

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HP30R and is the answer not in the manual?

Questions and answers

Table of Contents