Standard Compliance; Storage - Delta Amplon RT Series User Manual

radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct
the interference at his/ her own expense.

1.2 Standard Compliance

CE
RCM
KC
CB Report (by TUV)
EN 62040-1
EMC EN62040-2 C1

1.3 Storage

Prior to installation
If the UPS needs to be stored prior to installation, it should be placed in a dry
area. The allowable storage temperature and relative humidity (non-condensing)
are -15°C ~+50°C and 5~95% respectively.
After usage
Press the button, disconnect the UPS from the utility power, make sure the
OFF
UPS is shut down, remove all equipment from the UPS, and store the UPS in
a dry and well-ventilated area at a temperature between -15°C and +50°C and
at a relative humidity (non-condensing) between 5~95%. Idle batteries must
be fully recharged every three months if the UPS needs to be stored for an
extended period of time. Whenever you recharge the batteries (internal and
external), please fully charge them until the Battery Level Bar Graph
the UPS's LCD is fully on.
NOTE :
UPS to adjust to room temperature (20°C~25°C) for at least two hours to
avoid moisture condensing inside the UPS.
After storage and before start-up of the UPS, you must allow the
Chapter 1 Important Safety Instructions
7
shown on