Connecting To A Gas Supply; Gas Cylinder Requirements; Installing A Gas Connector To The Manifold - Pit Boss Ultimate Griddle Series Owner's Manual

GAS CYLINDER REQUIREMENTS

To operate, you will need a precision-filled standard G30/G31 grill liquid propane ("LP")
gas cylinder with external valve threads. Use standard flexible tube with length less
than 1.5 m (59 in). The tube shall be readily visible across its entire length for inspection
after installation.
The maximum diameter and the maximum height of the cylinder is 300 mm (11.8 in) and
600 mm (23.6 in) as shown in illustration.
CAUTION: You must have the proper regulator which relevant standard
is EN16129 and bottle in order for the barbecue to operate safetly and
efficiently. Use of an incorrect or faulty regulator is dangerous and will
invalidate any warranty. It is important to inspect the full length of the
tube. If it is evident there is excessive abrasion or wear, or the tube is cut,
the tube must be replaced prior to the appliance being used.

INSTALLING A GAS CONNECTOR TO THE MANIFOLD

Based on location and country of purchase, not all distributors sell the griddle with a regulator included. A Manifold Transition Kit
is provided should a gas regulator not come pre-assembled. Select the connector from the supplied Manifold Transition Kit that
is required for your gas manifold and regulator tubing. To ease installation of the gas connector, lift-off or disconnect the griddle
from the cart. Place upside-down on a piece of cardboard to prevent scratches or damage.
• CONNECTOR A - TAPERED
Insert the tapered end of the Connector into your
regulator tubing, then lock tight using a hose clamp.
Note illustration A.
CONNECTOR B - THREADED
•
Insert the threaded male Connector into the regulator
tube female end. Rotate to tighten completely.
Note illustration B.
Continue to next step for gas cylinder installation. Keep the griddle removed from the cart.
6

CONNECTING TO A GAS SUPPLY

300mm /
A
B
11.8 in
600mm /
23.6 in