ACME Ellipsoidal User Manual page 12

DMX Address
To select the DMX Address, press the ENTER button to confirm. Use the DOWN/UP button to adjust
the address from 1 to 512. Once the address has been selected, press the ENTER button to setup, to
go back to the functions without any changes, press the MENU button again. Hold and press the
MENU button for one second or wait for 30 seconds to exit the menu mode.
DMX Channel
To select the DMX Channel, press the ENTER button to confirm. Use the DOWN/UP button to select
1 Ch, 2D Ch or 2 Ch. Once selected, press the ENTER button to setup, to go back to the functions
without any changes, press the MENU button again. Hold and press the MENU button for one
second or wait for 30 seconds to exit the menu mode.
Dimmer Speed
To select Dimmer Speed, press the ENTER button to confirm. Use the DOWN/UP button to select
Fast (dimmer open fast) or Smooth (dimmer open smooth). Once selected, press the ENTER button
to setup, to go back to the functions without any changes, press the MENU button again. Press and
hold the MENU button about one second or wait for 30 seconds to exit the menu mode.
Dimmer Curve
To select Dimmer Curve, press the ENTER button to confirm. Use the DOWN/UP button to select
Mode1, Mode 2, Mode 3 or Mode 4. Once selected, press the ENTER button to setup, to go back to
the functions without any changes, press the MENU button again. Press and hold the MENU button
about one second or wait for 30 seconds to exit the menu mode.
Optically Linear: The increase in light intensity appears to be linear as DMX value is increased.
Square Law: Light intensity control is finer at low levels and coarser at high levels.
Inverse Square Law: Light intensity control is coarser at low levels and finger at high levels.
S-Curve: Light intensity control is finger at low levels and high levels and coarser at medium levels.
11G