Haivision Makito HVS-ID-QS-MAKD-130 Quick Start Manual

Download this manual

Makito

This Quick Start Guide summarizes the basic steps required to install the Makito Compact HD H.264 Video Decoder

(single chassis, as shown below) and set up video decoding from a Makito Encoder or a Hai1000 Mako Encoder.

Please refer to the User's Guide or the online help (available from the Web Interface) for detailed information.

To Install the Makito Decoder

Unpack the box and visually inspect the package contents for any evidence of shipping damage. [See Impor-

tant Notice for list of contents.]

Install the Makito as a desktop unit.

Connect the power cable.

CAUTION

Connect the power supply to the chassis first and then to the AC source. Always use the AC

power cord and power supply provided with the unit.

Make sure the connector is properly inserted and locked to avoid intermittent power problems.

To Connect the Makito Decoder to the Network and A/V Sources

Connect the Makito's Ethernet port to the IP network using an Ethernet UTP cable (Type Cat 5 or higher).

NOTE:

To connect the serial interface (on the Makito Decoder Dual Height Blade), please refer to the User's

Guide or the online help.

-130

HVS-ID-QS-MAKD

, Issue 01

™

Decoder Quick Start Guide

HVS-ID-QS-MAKD-130, Issue 01

Connect power supply here

Page 1 of 4

Page 1 HVS-ID-QS-MAKD-130, Issue 01 ™ Makito Decoder Quick Start Guide This Quick Start Guide summarizes the basic steps required to install the Makito Compact HD H.264 Video Decoder (single chassis, as shown below) and set up video decoding from a Makito Encoder or a Hai1000 Mako Encoder. Please refer to the User’s Guide or the online help (available from the Web Interface) for detailed information.
Page 2 Makito Decoder Quick Start Guide Video Out: Connect one or both of the Decoder’s Video Outputs to a plasma or other video display(s), using the appropriate connector(s): • 3G-SDI Video with Embedded Audio: Use the BNC connector. • HDMI Video with Embedded Audio: Use the HDMI connector. Analog 3G-SDI Audio Out...
Page 3 Makito Decoder Quick Start Guide Click from the main menu to open the page (shown below). ETWORK ETWORK ETTINGS Main menu Type in the IP Address Type in the new IP address. If required, select or enter other new value(s) in the appropriate field(s). To save your changes, click Save.
Page 4 Start the stream from the Encoder end and you should see video on your Decoder displays. For More Information Contact Haivision Technical Support via our Support Portal on our website at: http://www.haivision.com/support/ Or you may use the phone number or email address listed below: North America: Toll Free: 1.877.224.5445...