Energetics POWER RUN 4.9 Owner's Manual page 5

Assembly
1. Remove the treadmill from the shipping box and remote the console until it is in an appropriate
position and screw in one 806 bolt in both side handlebar--finger tighten only.
2. Lift the uprights to the unfolded position and screw using 2 ×810 Bolts, then tighten 810 bolts into the
base of upright, finally cover with 2 ×213 caps.
3. Remove bolt 806 from the left hand side then insert the handlebar 208. To fix use 1 × 806 and 1×
808. Repeat the same process for the right handle bar.
4. Secure both side handlebar using another 2 × 806 bolts and 2 ×808 washers.
5. Clip the handlebar cover over the handlebars and secure using 2×844 screws. Then repeat for the
other handlebar.
6. Attach the water bottle holder to the console housing-upper and push down until it snaps in place.
Handling
A. After assembly, the base frame can be adjusted to clear slightly uneven ground. Turn the adjustment
knobs on the bottom of the base frame to level the treadmill to the floor.
B. Lift the deck up from the rear of the treadmill and fold up until it locks in place (B1). TO PREVENT
INJURY BE SURE YOU HAVE A FIRM HOLD WHEN RAISING THE
sound as soon as the lock engages as shown in figure B2.
B1
C. To unfold the treadmill for use stand behind the treadmill and support the deck with your hands. Next
release the lock with your foot by stepping on the release lever as shown in figure C1. TO PREVENT
INJURY MAKE SURE YOU HAVE A FIRM HOLD ON THE DECK BEFORE RELEASING THE
LOCK. Slowly lower the deck as shown in figure C2 until it rests securely on the ground.
C1
2
1
B2
C2
5
DECK. You will hear a "click"