Operation In Offline Mode - Avery Dennison AP4.4 User Manual

05/04 Rev. 1.2-03
•
Configure Application A:
Dispenser The label is dispensed so that a small portion still sticks to the backing paper
above the dispensing edge. After the dispensed label has been removed by
hand, the next label is immediately printed and dispensed.
Set DISPENSER PARA > Dispenseposition to –6.0 mm (set to –8.0 mm if the
material is very adhesive).
Set DISPENSER PARA > Start Source > Light barrier .
•
Application B:
The printing and dispensing of the label is triggered by a signal from the foot
switch connected.
Set SYSTEM PARAMETER > External Signal > Stacker full.
Set DISPENSER PARA > Dispenseposition to –6.0 mm (set to –8.0 mm if the
material is very adhesive).
Set DISPENSER PARA > Start Source > Foot switch .

Operation in Offline Mode

Display before Button pressed
OFFLINE x JOBS Online
OFFLINE x JOBS Online
Stopped xx
OFFLINE x JOBS Online + Feed
OFFLINE x JOBS Online + Cut
OFFLINE x JOBS Online + Cut +
Feed
OFFLINE x JOBS Prog
OFFLINE x JOBS Feed
OFFLINE x JOBS Cut + Feed
Tab. 6: Button combinations in the offline mode (x = Number of print jobs; xx = The remaining number of labels to
be printed in the current print job)
All manuals and user guides at all-guides.com
USER MANUAL
AP4.4 – AP5.4
Display after
ONLINE
ONLINE
Stopped
OFFLINE
feeding...
OFFLINE
feeding...
OFFLINE
PRINT INFO
OFFLINE
feeding...
OFFLINE
Head dot test
Function
x JOBS Online mode
x JOBS Switches to the online mode
xx when print job is stopped
x JOBS Slower material and foil feed
x JOBS Material travels backwards un-
der the printhead
x JOBS Reset
Parameters menu selection
x JOBS Feeds material until next perfo-
ration is reached or as long as
the button is held down
x JOBS Tests the printhead for defective
dots
17
Setup & Operation