Avery Dennison AP4.4 User Manual page 4

05/04 Rev. 1.2-03
Tool which is used to replace the print roller and to mount a dispensing edge.
•
AP 5.4 with Cut- Cutter (Fig. 4)
ter Only if you ordered the "AP 5.4 peripheral with cutter".
Fig. 4:
You can find instructions on how to mount the cutter in the cutter manual under
"Connection, Setup, Service".
fixed to the printer bottom.
•
AP 5.4 with In- Printer with mounted deflector
•
ternal Rewinder Housing front part, bottom side with screw (fig. 5 right side)
•
Cutter flange cover with screws (fig. 5 left side)
standard device without rewinding function.
Fig. 5:
•
AP 5.4 Dispen- Printer with mounted dispensing edge
•
ser Housing front part, bottom side with screw (see fig. 6)
•
Cutter flange cover with screws (see fig. 6)
•
Deflector (see fig. 6)
Enables the AP 5.4 Dispenser to be operated with internal (label material)
rewinder.
standard device without dispensing or rewinding function.
All manuals and user guides at all-guides.com
USER MANUAL
AP4.4 – AP5.4
If ordered, you will find the cutter in a special carrier in the top of the printer pak-
kaging.
The cutter hook, a part which is required to mount the cutter, can be found
It is recommended to mount the housing parts, if the printer is used as a
These housing parts are shipped loose with the „AP 5.4 Internal Rewinder".
It is recommended to mount the housing parts, if the printer is used as a
4
Setup & Operation