Setting Up Your Save-To-Disk File Allocation - Fujitsu 420D User Manual

selection it will load the operating system and
begin operation.
Get Default Values:
Sel ecting Get Default Va lues wi ll load the factory
pre s et default va lues for all menu fiel d s . Wh en
the load is com p l ete the Setup Uti l i ty wi ll dis-
p l ay the message Default values have
been loaded.[Continue] . Wh en any key is
pre s s ed the Setup Uti l i ty wi ll retu rn to the Ex i t
Menu . To retu rn to another menu fo ll ow the
d i recti ons in the Navi ga ting Th ro u gh The Setu p
Uti l i ty Secti on . (See pa ges 48–49.)
Load Previous Values:
Sel ecting Load Previous Va lues wi ll load the
BIOS mem ory va lues for all menu fiel d s . Wh en
the load is com p l ete , the Setup Uti l i ty wi ll dis-
p l ay the message Previous values have
been loaded [Continue] . Wh en any key is
pre s s ed the Setup Uti l i ty wi ll retu rn to the Ex i t
Menu . To retu rn to another menu , fo ll ow the
d i recti ons in the Navi ga ting Th ro u gh The Setu p
Uti l i ty Secti on . (See pa ges 48–49. )
Save Changes:
Selecting Save Changes will cause the new
C o n f i g u r i n g Y o u r L i f e B o o k 4 0 0 S e r i e s
settings in all menus to be written to the
BIOS memory. When saving is complete the
message Changes have been saved
[Continue] will be displayed. Pressing a
key will return the Setup Utility to the Exit
Menu. To return to another menu, follow the
directions in the Navigating Through The
Setup Utility Section. (See pages 4 8 – 4 9.)
Setting Up Your Save-To-Disk
File Allocation
Your notebook comes with an allocation of
space on the internal hard drive adequate to
operate the Save-to-Disk function for the
amount of memory installed at the factory.
If you add a RAM Module or do not use the
Save-to-Disk function and wish to free up the
disk space you will need to change the alloca-
tion. The utility to change the allocations is
PHDISK.EXE and is activated from the
MS-DOS prompt.
PHDISK allows you to perform five di erent
functions related to the Save-to-Disk space on
the internal hard drive. They are:
L i f e B o o k 4 0 0 S e r i e s f r o m F u j i t s u
1. All oc a te a space for the Save - to - Disk functi on .
2. Remove all space allocation for the Save-to-
Disk function.
3.Find out details about the hard drive and the
current Save-to-Disk space allocation.
4. Re-allocate space and mark bad blocks in the
space allocated to the Save-to-Disk function
when a disk error has occurred.
5. Find out how mu ch space is needed to perform
the Save - to - Disk functi on with the curren t
m em ory con fig u ra ti on and how mu ch unu s ed
s p ace is ava i l a ble on the internal hard drive .
To find out how much space is needed to per-
form the Save-to-Disk function with the cur-
rent memory configuration and how much
unused space is available on the internal hard
drive, do the following:
1. Go to the MS-DOS prompt.
(In Windows 95 go to the Start Menu and
select MS-DOS Prompt.)
2. Type CD C:\Fujitsu
75