Cd-Rom Drive - Fujitsu 420D User Manual

CD-ROM Drive

The modular C D - ROM Drive is a 10-speed
re ader.
C A U T I O N
Do not operate the CD-ROM drive
unless your notebook is sitting on a flat
surface and the tilt adjustment feet are
folded against the bottom of your note-
book. Using a CD when the drive is not
level may damage the drive or prevent
proper operation.
Loading a CD
Make sure that the tilt adjustment f eet (See
Figure 1-9 on page 8) on the bottom of your
notebook are folded against the bottom.
Make sure there is power to your notebook.
Push, gently but firmly, and release the eject
button on the front of the CD-ROM drive to
open the CD-ROM holder tray, the tray will
come out a short distance.
Gently pull the tray out until a CD-ROM can
be easily placed in the tray.
U s i n g Y o u r L i f e B o o k 4 0 0 S e r i e s
Make sure that the protective sheet that
was in the tray when it was shipped has
been removed.
Place a CD into the tray, label side up, with
the hole in the center of the CD snapped
onto the raised circle in the center of the tray.
Close the tray.
After a CD is loaded,it will take a short time
for your notebook to recognize it.
P O I N T
If you have disabled the automatic inser-
tion function you will have to start the
CD from the desktop, as your notebook
will not automatically recognize that a
CD has been loaded.
Care of CD-ROMs
CD-ROMs are precision devices and will func-
tion reliably if given reasonable care.
Always store a CD-ROM in its case when it is
not in use.
L i f e B o o k 4 0 0 S e r i e s f r o m F u j i t s u
When removing a CD-ROM from its case,
press down on the holder's center while lift-
ing out the CD-ROM by its edges.
Always handle a CD-ROM by the edges and
avoid touching the surface.
Avoid storing any CD-ROM where there are
temperature extremes.
Do not bend CD-ROMs or set heavy objects
on them.
Never write on the label surface with a ball
point pen, pencil or similar device.
If a CD-ROM is subjected to a sudden
change from cold to warm condensation may
form on the surface. Wipe the moisture o
with a clean,soft,lint free cloth and then let
it dry at room temperature. DO NOT use a
hair dryer or heater to dry a CD-ROM.
If a CD-ROM is dirty, use only a CD-ROM
cleaner or wipe it with a clean,soft,lint free
cloth starting from the inner edge and wiping
to the outer edge.
35