Exiting From The Boot Menu; Exit Menu - Leaving The Setup Utility - Fujitsu 420D User Manual

S e c t i o n T h r e e
POSTErrors:
The POST Errors field allows you to disable
the display of error messages when the Power
On Self Test finds problems.
Floppy Check:
The Floppy Check Field entry enables or
disables the system from checking what kind
of floppy disk is installed e very time it boots
up. Disabling this makes the boot a little bit
faster. The default is Disabled.

Exiting from the Boot Menu

When you have finished setting the parame ters
on the Boot Menu, you can either exit from the
Setup Utility or move to another menu. If you
wish to exit from Setup Utility press the Esc key
to go to the Exit Menu. If you wish to move to
another menu,use the cursor keys.
Exit Menu – Leaving the Setup Utility
The Exit Menu is used to leave the Setup Utility.
The Exit Menu options are:
Save Changes and Exit:
Sel ecting Save Ch a n ges and Exit wi ll store all
the en tries on every menu of the Setup Uti l i ty
74
to the B I O S m em ory and then exit the Setu p
Uti l i ty. Wh en saving is com p l ete the message
Changes have been saved
[Continue] wi ll be displayed . Pressing any
key wi ll reboot your noteboo k .
Figure 3-10 Exit Menu
Discard Changes and Exit:
Selecting Discard Changes and Exit will exit
the Setup Utility without writing to the
BIOS memory. When BIOS recognizes this