Shutting Down And Restarting - Canon COLORPASS-Z6000 PS-NX6000 Installation And Service Manual

3
T
O SHUT DOWN THE
3-16
Connecting the ColorPASS

Shutting down and restarting

The ColorPASS will probably be left on all the time at the customer site. Remember that
when the ColorPASS is powered off, network access to the copier is interrupted.
Shut down the ColorPASS when you need to service it or the copier, and before you
remove or attach any cables to the ColorPASS. Shut down the ColorPASS before
changing the copier's toner cartridge in order to prevent the fan from drawing toner into
the ColorPASS.
C PASS
OLOR
Always verify that the ColorPASS is not in use before you shut it down.
1. Make sure Idle is displayed on the ColorPASS Control Panel.
When Printing or Ripping appears on the Control Panel, the ColorPASS is currently
processing a job. Idle is displayed on the Control Panel when the ColorPASS is finished
processing the job.
2. At the Idle screen, press the Menu button once to display the Functions menu.
3. Scroll to select Shut Down from the Functions menu.
Print Pages
Scan Job
Suspend Printing
Resume Printing
Functions
Shut Down
Clear Server
Run Setup
Run Diagnostics
Functions
4. At the next screen, select Shut Down System.
Restart Server
Shut Down System
Reboot System
Shut Down
If you are recycling power, wait at least 10 seconds before powering back on.
N :
OTE
If you are unable to access the Shut Down menu to shut down the ColorPASS (for
example, if the system hangs), power off by holding down the power button for up to 8
seconds.
Use the line selection
button to the right to
select Shut Down
Use the line selection
button to the right to
select Shut Down System