5
Preliminary on-site checkout
Checking external connections
Before removing the side and front panel of the ColorPASS to check internal
components, first eliminate the most obvious sources of problems. Make sure that:
• All interface cables to the system are plugged into the proper connectors on the back
panel of the ColorPASS (see Figure 5-2).
• The power cable is plugged into the wall power outlet.
• The LED on the network connector is blinking to indicate network activity.
Power cable
connector
Mouse (option)
Keyboard (option)
USB ports (ES-1000)
Parallel port (dongle)
Serial port (ED-100)
Monitor (option)
10/100/1000BaseT
Not used
Empty slot
Empty slot
Copier interface board
Empty slot
Empty slot
Empty slot
Empty slot
F
IGURE
If all the connectors are properly in place and the power is on, proceed to the next stage
of troubleshooting.
Back panel of the ColorPASS
5-2
5-3