Table of Contents
Advertisement
4
4-58
Service Procedures
5. Select Restore system from the following menu.
Select Option:
Restore system
Restore/Update CD
Select Option:
Update system
Restore/Update CD
6. When the message "All date will be deleted. Continue?" appears on the Control Panel,
make sure "Yes" is displayed, and then select OK.
The restore backup process begins immediately.
The Control Panel displays screens indicating that the software is being restored.
7. At the message "Restore complete!" press the fourth line selection button to select OK.
8. Scroll to Exit and press the fourth line selection button to select OK.
9. At the message "Remove CD and recycle power," remove the Restore/Update Server
Software CD from the CD-ROM drive, and then power off the ColorPASS by holding down
the power button for up to 8 seconds. Wait 10 seconds, then press the power button to
power the ColorPASS back on.
After you power on, the ColorPASS organizes the software on the system and then
reboots once (twice, if the FACI option is enabled) to complete software installation.
This segment takes approximately 7 to 10 minutes. Wait for the Idle screen to display.
10. Install any required software patches or updates according to the instructions provided
with the patch or update CD.
Check the Update Information section of the Configuration page you printed earlier to
see if there are any patches or updates that you need to reinstall. For detailed installation
instructions, see the documentation provided with the specific patch or update CD.
11. Configure Setup using the Configuration page you printed earlier.
At the Idle screen, press the Menu button once to access the Functions menu. Scroll
down and then select Run Setup . Bypass any settings that are not included on the
Configuration page if it is more appropriate for the network administrator to set them.
The system reboots after you exit Setup. For more information, see the
Configuration Guide.
12. Reinstall fonts, user software, or custom simulations that were deleted when you
restored system software.
Press the 4th line selection button
OK
Not used in this procedure
OK
Advertisement
Table of Contents
