Appendix B: Replacing Top And Side Plastics; Procedures - Canon COLORPASS-Z6000 PS-NX6000 Installation And Service Manual

B
Appendix B:
Replacing top
and side plastics
T
O DISASSEMBLE A SIDE PANEL
Screw
Metal piece
Plastic piece
Hook
(1 of 5)

Procedures

This appendix describes how to replace the top panel and the plastic piece of a side panel
on the ColorPASS.
Procedures
You may need to replace the top panel or the plastic piece of a side panel if the plastic
becomes damaged. The following procedures describe how to remove and replace these
plastic parts.
The term "side panel" refers to both the plastic and metal pieces of a side panel
N :
OTE
joined together. The term "plastics" refers to just the plastic piece. You should only need
to separate the pieces to replace damaged plastics. You do not need to separate the pieces
to open the ColorPASS for routine service.
1. Shut down the ColorPASS (see page 4-4).
2. Remove the side panel (see page 4-5).
3. Place the panel on a flat, padded surface.
4. Remove the screw that attaches the metal piece to the plastic piece.
5. Separate the metal and plastic pieces.
Pull the metal piece over the two posts, slide the metal piece in the direction of the arrows
to disengage the hooks, and then lift the metal piece to separate.
Disassembling a side panel
F B-1
IGURE
Posts
B-1