Table of Contents
Advertisement
4
Motherboard
7. At the message "Update Complete!" select OK.
8. Scroll to Exit and select OK.
9. At the message "Remove CD and recycle power," remove the CD and shut down the
ColorPASS (see page 4-4).
10. Remove the dongle and mark it "used" by peeling off the circle on the label.
Reinstall any dongle previously removed.
The new motherboard is now updated and cannot be used in another system.
11. Power on the ColorPASS using the power button on the front panel and allow the system
to reach Idle.
If an error message appears on the Control Panel, see the following section.
Error messages
The following error messages may appear on the Control Panel LCD if a required system
update is not done.
Wrong/Missing. . . dongle—
repeat the system update procedure.
The single-use dongle has already been used to update a system and
Used dongle—
cannot be used again. Obtain an unused dongle and repeat the system update procedure.
This message appears if the motherboard in the system is new, has not
Invalid license—
been updated, and the system is not in Service Mode. It appears for approximately 15
seconds before you see the message "It is now safe to power off the system."
(Unrelated to the system update procedure, this message also appears anytime you
attempt to install the wrong system software, that is, software designed for another
product.)
Hardware mismatch. Shutdown in progress—
from the old motherboard was transferred to the new motherboard. BIOS chips are not
interchangeable. Do not transfer the BIOS chip from the old motherboard onto the new
motherboard.
Unknown platform—
not been done. You are most likely to see this message if you attempt to reinstall system
software before updating the system. Perform the system update using the one-time use
dongle and the Restore/Update Server Software CD.
No service dongle—
the dongle while the ColorPASS is in Service Mode.
If an error condition cannot be corrected, restore the previous configuration, if possible,
and contact your authorized service support center.
The system was not updated. Install the correct dongle and
This message is displayed if the BIOS chip
This message is displayed if the update procedure is required but has
This message appears for approximately 15 seconds if you remove
4-33
Advertisement
Table of Contents
