Specification - Philio PAN15-2 Manual

2. The switch is protected
The Switch LED 1. Not carry out
illuminating, but the association
Detector cannot control 2. Same frequency
the Switch interference
LED keep flashing, but Overload occurs
cannot control

Specification

Operating Voltage 100~120Vac/ 60Hz; 220~240Vac/ 50Hz
Maximum Load 13A ( Resistive Load)
Range Minimum 40 m in door 100m outdoor line of sight
Operating Temperature 0° C ~ 40° C
Frequency Range 908.4MHz & 916.0MHz/ USA (PAN15-1);
922~927MHz/ Taiwan/ Japan (PAN15-2)
** Specifications are subject to change and improvement without notice.
FCC ID : RHHPAN15
Warning:
1.Plug out to disconnect from power supply; Do not plug in line.
2. Do not exceed the max rating
Disposal
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling
1. Carry out association
2. Wait for a while to re-try
Remove the load attached or check max.
load cannot exceed 13.0A
Company of License Holder：Philio Technology Corporation
Address of License Holder：8F., No.653-2, Zhongzheng Rd., Xinzhuang Dist., New
Taipei City 24257, Taiwan(R.O.C)
FCC Interference Statement FCC Interference Statement
FCC Interference Statement FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
7