BMW X4 Owner's Manual page 175

Deactivate Automatic High Beam
Assistant
Press the button on the turn signal lever.
Sensitivity of the Automatic High
Beam Assistant
General information
The sensitivity of the Automatic High Beam As‐
sistant can be adjusted.
Safety information
Warning
If adjustments have been made or the sensitiv‐
ity has been modified, oncoming traffic may be
momentarily blinded. There is a risk of accident.
If adjustments have been made and the sensi‐
tivity has been modified, make sure that on‐
coming traffic is not momentarily blinded.
Switch off the high beams manually if required.
Functional requirements
▷ Setting at standstill only.
▷ Drive readiness is switched on.
▷ Light is turned off.
Increase sensitivity
Push the turn signal lever to the front for approxi‐
mately 10 seconds.
A Check Control message is displayed. The sys‐
tem responds more sensitively.
Online Edition for Part no. 01405A37CC6 - VI/21
Lights
Resetting the sensitivity
Push the turn signal lever to the front again for
approx. 10 seconds or switch off the drive-ready
state.
The sensitivity of the Automatic High Beam As‐
sistant is reset to the factory settings.
System limits
The Automatic High Beam Assistant cannot re‐
place the driver's personal judgment of when to
use the high beams. In situation that require this,
therefore dimming manually.
The system is not fully functional in the following
situations, and driver intervention may be neces‐
sary:
▷ In very unfavorable weather conditions, such
as fog or heavy precipitation.
▷ When detecting poorly-lit road users such as
pedestrians, cyclists, horseback riders and
wagons; when driving close to train or ship
traffic; or at animal crossings.
▷ In tight curves, on hilltops or in depressions,
in crossing traffic or half-obscured oncoming
traffic on highways.
▷ In poorly-lit towns and cities or in the pres‐
ence of highly reflective signs.
▷ When the windshield in front of the interior
mirror is fogged up, dirty or covered with
stickers, etc.
Laser high beams
Principle
The headlight range of the high beams is in‐
creased and provides better illumination of the
road.
General information
When the high beams are switched-on, starting
with a speed of approx. 37 mph/60 km/h, the la‐
ser high beams in the headlight are automatically
switched on in addition to the LED high beams.
CONTROLS
175