Table of Contents
Advertisement
Instrument Setup (
Installation
Install the Reichert 7 Series Chinrest assembly according to the
following procedure.
Note: The Reichert 7 Series Chinrest is compatible with the
Reichert 7 and Reichert 7CR.
1. Set the Reichert 7 on its side so that the Chinrest assembly
can be installed onto the bottom of the unit. (Refer to
Figure 1-2)
2. Remove the two screws that secure the connector access
plate. Remove the access plate and attach the screws
from where they were removed to secure the connector
interface plate. Put the access plate in with the shipping
container for future use, if needed.
3. Attach the Chinrest assembly connector to its mating
connector on the bottom of the Reichert 7.
(Refer to Figure 1-3)
4. Attach the connector from the UP/Down Switch to the back
side of the Chinrest assembly (Refer to Figure 1-4) and
run the cable behind the chinrest assembly, between the
chinrest assembly and the patient side of the instrument.
Continue routing the cable under the instrument so that it is
out of view to the patient.
5. Position the Chinrest assembly so that the mounting holes
on the Chinrest assembly align with the holes on the bottom
of the unit. (Refer to Figure 1-5)
6. Secure the Chinrest assembly to the bottom of the Reichert
7 with the screws supplied with the Chinrest assembly.
7. Attach the three rubber bumpers or the hook-and-loop
fasteners to the bottom of the UP/Down Switch as desired.
If using the Hook-and-loop fasteners, secure the other side
to the other desired surface. (e.g., unit, table, etc.). (Refer to Figure 1-6)
Note: There are no fuses in this instrument and disconnection of the Reichert 7 Series Chinrest is per-
formed by removing the connection from the bottom of the instrument.
Up/Down
Switch Connector
Figure 1-4, Switch Connector
16049-101 Rev. D
)
Continued
Mounting Screw Holes
Figure 1-5, Switch Connector
Connector Access Plate
Figure 1-2, Reichert 7 Bottom
Figure 1-3,
Rubber Bumpers
Figure 1-6, Switch Bumpers
7
Advertisement
Table of Contents
