HIKVISION DC-2CD20 Series User Manual page 101

Generation Speed (Time) [0~100]: The speed of the head or should be
treated as a target. If you set the value lower, the head or shoulder will not be
recognized as a target in the configured area if it is there from the start.
Counting Speed: It refers to the speed of the camera calculates the entered
and left people.
Target Size Correction [0~100]: It corrects the frame size according to the
actual environment. If the camera detects the detection frame is obviously
larger than the actual head or shoulder, adjusting the value can correct the
detection frame so as to close to the actual head or shoulder. The default value
of 50 is recommended.
Detection Type: It refers to the detection type of the camera recognize a target.
Auto, Head, and shoulder are selectable. Auto is recommended.
7. Configure the mounting related parameters.
Camera Viewing Angle: Refers to the mounting type of the camera. Vertical
and tilt are selectable, and vertical is recommended.
Mounting Height: It is recommended that you select the proper mounting
height according to the lens you adopts.
Focal Length: The zoom lens with the small focal length is recommended.
8. Set the camera calibration.
(1): Check the checkbox of Camera Calibration to enable the function.
(2): Click Calibrate to draw two calibrate frames. It is recommended you draw
two calibrate frames in different distance, so the camera can judge the size of
the head or shoulder in different distance.
Note:
The camera calibration is disabled by default. You can enable calibration to
improve the calculation accuracy when there is an obvious misinformation
during the counting.
9. Click Edit to set the arming schedule.
10. Select the linkage method by checking the checkbox of notify the surveillance
center.
11. Click Save to save the settings.
 People Counting Statistics
Steps:
User Manual of Network Camera
100