Table of Contents
Advertisement
3.1 Unpacking
To unpack the flat bezel panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat bezel panel PC has
been properly installed. This ensures the screen is protected during the
installation process.
Step 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4:
Lift the monitor out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the flat bezel panel PC.
Step 7:
Make sure all the components listed in the packing list are present.
3.1.1 Packing List
The AFL2-12A-HM65 flat bezel panel PC is shipped with the following components:
Quantity Item
Standard
1
AFL2-12A-HM65 panel PC
Page 20
AFL2-12A-HM65 Series Panel PC
Image
Step 0:
Advertisement
Table of Contents
